Home > Blogs > Detail

Banana PI BPI-M2 Berry Quad-core Mini Single Board Computer Development Board

12 Nov 2025 15:01:11 GMT管理员
Description:
The Banana PI BPI-M2 Berry quad-core single board computer is developed with Allwinner A40li chip. It supports onboard Wifi and Bluetooth, supports SATA interface, and can be directly connected to a hard disk. There is an SD card slot on the board, which can boot the system image from your SD card.

Banana PI BPI-M2 Berry is highly compatible. It can run systems for Android, Debian, Linux, Ubuntu Linux, Raspberry Pi and Allwinner Tina Linux.

As a member of the Banana Pi family, the Banana PI BPI-M2 Berry is a direct upgrade to the Banana Peel M1/M1+, supporting SATA.

Features:
* Allwinner A40i-H quad core Cortex-A7 CPU for ARM
* 1GB DDR3 SDRAM RAM
* Onboard WiFi (AP6212) & Bluetooth
* SATA hard disk interface
* 4*USB2.0 interface
* MIPI DSI display interface

* CSI camera interface


Hardware Specifications:
* Soc: Allwinner A40i-H
* CPU: quad-core Cortex -A7
* GPU: dual-core MALI-400 MP2 and runs at 500MHz, capable of 1.1 Gpixel/s throughput. Graphics capabilities are slightly higher than the original level (for Xbox) of performance. The GPU provides OpenGL ES 2.0, hardware-accelerated OpenVG, 1080p45 H.264 high-profile encode and decode.
* SDRAM: 1GB DDR3 with 733MHz/(shared with GPU)
* SATA: support SATA interface
* GPIO: 40 Pins Header, 28xGPIO, some of which can be used for specific functions including UART, I2C, SPI, PWM, I2S
* On board Network: 10/100/1000Mbps Ethernet /(Realtek RTL8211E/D)
* Wifi Module: WiFi 802.11 b/g/n /(AP 6212 module on board)
* Bluetooth: BT4.0
* On board Storage: Micro SD /TF card, No eMMC onboard
* Display: 4-lane MIPI DSI display,or RGB panel or LVDS panel, TV-out on HDMI-compatible V1.4
* Video: Multi-format FHD video decoding, including Mpeg1/2, Mpeg4, H.263, H.264, etc. H.264 decode up to 1080P60, support video encoding: High-definition/(HD) H.264 video encoder is up to 1080P at 45fps
* Audio outputs: HDMI-compatible, analog audio /(via 3.5 mm TRRS jack), I2S audio /(also potentially for audio input)
* Camera: A CSI input connector camera: Supports 8-bit YUV422 CMOS sensor interface, supports CCIR656 protocol for NTSC and PAL, supports 5M pixel camera sensor, supports video acquisition solution up to 1080p at 30fps
* USB: 4 USB 2.0 host, 1 USB 2.0 OTG
* Buttons: Reset button, Power button, U-boot button
* LEDs: Power status Led and RJ45 Led
* IR: No onboard IR receiver
* DC Power: 5V/2A with micro USB port
* Battery: No 3.7V lithium battery power support (battery not included)
* Sizes: 85mmx56mm, same size as raspberry pi 3
* Weight: 40g





Latest release